Filter
Top Products
For models with more than three buttons:
Push
a
Cycle Selector button for the desired
cycle. Use any Cycle Selector button with the
Rinse 8 Hold cycle. The Cycle Control knob
determines which cycle operates.
3. Turn the Cycle Control knob clockwise to point
to the desired cycle. See page 8 for cycle
descriptions.
Cyclem may vary with models
You will feel a definite stop at each cycle mark.
The dishwasher will automatically start the cycle
you selected.
NOTE: lf the door is latched, you will hear
cycles start and stop as the knob passes each
cycle mark. Thii is normal and will not hurt the
dishwasher. lf you prefer, you can set cycles
with the door unlatched.
Adding a dish during a cycle
(model series WU3000 and WU4000, WUS750)
You can add an additional item to the dishwasher anytime before the Cycle Control knob
reaches LIGHT WASH. See page 8.
1.
Lift up on the door latch to unlatch the
Wait 30 seconds for air in the dishwasher
door and stop the cyde. Wait a moment
to warm up. This helps reduce the
for the spray action to stop before open-
amount of moisture that can come from
ing the door.
the vent when restarting the cycle.
2. Cpen the door and add the dish.
4. Press door in to latch it. The dishwasher
3. Close
the door.
Do not latch It.
will start where it stopped.
Changing a cycle setting
(model series WU3000 and WU4000, WU5750)
You can change a setting anytime during any cycle.
1. Lii up on the door latch to unlatch the NOTE: Turning the Cycle Control knob
door and stop the cycle. may cauw the covered section of the
2. Turn the Cycle Control knob clockwise to
detergent dispenser to open. Be sure to
the cycle you want.
fill the covered section,
and
dose the
3. Check the detergent dispenser to be sure
cover, if the cycle uses detergent in
it is properly filled for the new cycle. See
both sections.
page 10.
4. Close and latch the door. The dishwasher
will automatically start the new cycle.
Canceling a cycle
You can cancel
a
cycle anytime during the cycle.
1.
Turn the Cycle Control knob &My
2. Let the dishwasher drain completely.
clockwiie to the drain portion of the wash
or rinse. You will hear water draining
3. Lii up on the door latch to unlatch the
door.
when you have advanced to the proper
location.
4. Turn the Cycle Control knob dockwise to
point to OFF.
7