Filter
Top Products
28
Installation Instructions
General
Any electrical work required to install this ap-
pliance should be carried out by a qualified
electrician or competent person.
Any plumbing work required to install this ap-
pliance should be carried out by a qualified
plumber or competent person.
– The dishwasher is delivered ready for connection,
i.e. with power supply cable, drain hose and inlet
hose with fitted filter and seal.
– The installation should be carried out to connec-
tions provided in a neighboring cupboard (not di-
rectly behind the unit).
– The regulations of the local water and electricity
companies must be complied with.
Do not dismantle the unit! The installed water–
softener contains water, which can escape.
Water supply connecĆ
tion
– The unit must be connected to a cold water supply.
– The water pressure must be within the limits given
in the technical specifications (1 to 10 bar running
water pressure). Your local Water Authority will ad-
vise you on the average mains pressure in your
area.
– A shut–off device with a ¾” connection must be
provided on site.
– The inlet hose has a filter to remove any impurities
from the water supply and a rubber seal. When fit-
ting ensure that the filter and seal are correctly po-
sitioned.
No water must escape from the fitting after the
shut–off device has been opened.
Do not use, for connection, old hoses which
have been used in another appliance.
Water outlet hose conĆ
nection
– Ensure the drain hose is not bent or squashed as
the could prevent or slow down the discharge of
water.
– The outlet hose should be connected to a water
outlet provided in a neighboring cupboard (not di-
rectly behind the unit).
– The dishwasher is fitted with a device to prevent
the back flow of water, which allows the installation
height of the unit to be above the outlet height.
– The highest point of the drain hose should never
exceed the unit height.
86 – 91 cm