Filter
Top Products
9
Prior to Using for the first Time
Do the following steps before using your dishwasher
for the first time.
Fill with rinse aid
1. If the display indicator is lit, open the dispenser by
pushing button (A).
2. Fill with rinse aid up to the ”max.” marking (B). Do
not exceed the maximum container quantity of
150 ml!
3. Close the dispenser.
4. Immediately remove any spilled rinse aid, as
otherwise foaming can occur.
The rinse aid indicator goes out.
Setting the rinse aid
dosage
1. Open the dispenser (A).
2. To increase the dosage (B), turn the dosage arrow
to the left using a coin or a screwdriver. The factory
setting is Level 3 (ideal setting level 2 – 4).
3. Close the dispenser.
For further information see page 24, ”Something Not
Working”.
Filling the salt
dispenser
Never fill the salt dispenser with rinse aid or
detergent!
Use only special dishwasher salt in your dishwasher.
Fill with salt as follows:
1. Open the cap (A) of the salt dispenser.
2. Fill the dispenser with water (B).
3. Fill with 1 kg of special salt (C). As a result, approx.
1 litre of water will be displaced.
4. Remove salt from around the opening of the dis-
penser.
5. Close the salt dispenser by turning the cap until the
stop is reached.
6. Immediately run a wash programme except the
”Pre–wash” to wash away any salt residues.
The salt display will go off after 1 or 2 rinse cycles.
Do not remove the water feed valve, and do not
fill with detergent for any reason.
A
B
C