1. Manuals
  2. Kitchen Appliance Support
  3. Fisher & Paykel Support
  4. Oven Support
Support User Manuals
Question About Fisher & Paykel Oven ra6102
replacing oven seal...

need help replacing oven seal, please.

Asked by cilla on 02/04/2011 4  Answers

ManualsOnline posted an answer 13 years, 10 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

George posted an answer 13 years, 9 months ago

4 I don't know the oven you refer to, but I have a stand alone stove and just replaced the seal today. You have to take off the back panel (thin galvanized iron) There are two bolt you have to undo about 15-20mm. The oven liner will slide out at the front by this amount and the seal can be replaced quite easily.
Was this answer helpful?

Nigel posted an answer 12 years, 5 months ago

4 This applies to the OR61 series ovenranges too. You really have to know abut those two bolts!
Was this answer helpful?

dave posted an answer 10 years, 7 months ago

0 excellent advice
Was this answer helpful?

Graham posted an answer 10 years, 1 month ago

0 oregano RA6102 double oven. Slightly different back rail, but same hex-headed galvanised screw rather than bolts to go looking for - similar placement to photo above. Had a bit of further trouble due to the oven vent stub at the top of the oven being 'gummed' into place. removed this at the top back of the back panel and then carefully re-located this on re-assembly and ensured it was correctly in place. . .
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual