I have a Kenmore side by side refridgerator/freezer model 363.58577892 serial #85029187. my original ice maker got stuck in the heat mode and was melting all the ice in the bin so I too the unit out and went to sears and got a new WR30x10093 ice maker to replace it. It nevermade ice. I then replaced the dual water valve , the ice side coil was shot. I still am getting no water to the ice maker. I guess my next question is - On the female 4 pin connector in the freezer what should the voltage be going to the ice maker? the New WR30x10093 has the adapter harness and is very difficult to manuver in, I want to check the voltage there also without it plugged into the icemaker. My last question is haow do I cycle this unit ? It has no points to jumper to manually cycle the unit, also where should the home position be for the unit to start? Right now the eject fingers are at the 9:00 position just past the mold. The water line is not fozen, I just took it off and blew through it.