1. Manuals
  2. Kitchen Appliance Support
  3. Kenmore Support
  4. Range Support
Support User Manuals
Question About Kenmore Range 95014102
My self cleaning oven remained locked after cleani...

My self cleaning oven remained locked after cleaning, Shows error message E1 and F5. What does this mean?

Asked by Barb on 11/21/2013 1  Answer

ManualsOnline posted an answer 10 years, 5 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Rewarder User posted an answer 10 years, 1 month ago

5 Try powering off by removing power plug for 30 seconds and see it it resets. If it continues you need the board replaced. This is a common problem due to the ERC getting too hot during the self cleaning process. I had mine replaced under warranty and the problem did not return so it might be worth doing once even if it is out of warranty. I have attached error codes below. F1 - E0 EEPROM communication error 1. Disconnect power for at least 30 seconds. 2. Re-apply power and observe for at least one minute. 3. If code re-appears, replace control board (also called ERC or clock). Note: Applies to all F1-E... codes except F1-E3. F1 - E1 EEPROM checksum error F1 - E2 UL A/D error(s) F1 - E4 Model ID error F1 - E5 Calibration shifted F1 - E6 Latch signal mismatch error F1 - E9 Stack overflow
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual