1. Manuals
  2. Kitchen Appliance Support
  3. Kenwood Support
  4. Dishwasher Support
Support User Manuals
Question About Kenwood Dishwasher kid60b10
KID60B10 No Power despite plugged in and the plug ...

KID60B10 No Power despite plugged in and the plug fuse was fine. it showed -:-- the day before but wouldnt cycle,then died. TAKE MAINS PLUG OUT Remove the kitchen door fascia & screws inside the top of the door that hold the control panel on. Carefully tilt the panel to reveal the fuse. Check it's good &REMOVEthe fuse. Check all lead connectors &make sure sound. Also check for any burnout (mine was fine). Put the fuse back in to reset it..rebuild.fixed!

Asked by Dave on 02/08/2015 1  Answer

ManualsOnline posted an answer 9 years, 9 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Dave posted an answer 9 years, 9 months ago

0 Seems that the act of removing the internal thermal fuse acts to reset the dishwasher - it is immediately fixed!! As stated above, you need to remove the plug from the mains entirely - for safety reasons but it may also be relevant to force a reboot/reset? I dont know - but safety first!!! I also cant vouch that there's no capacitor or built up charge in there so be careful and wear rubber shoes :)
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual