Other Coffeemaker DGB-600BCC coffee maker not working, beeps as soon as I plug it in

Grind and Brew Thermal DGB-600 I can't get past the beeping to start the coffee maker

Asked by mindy on 03/05/2009 58 Answers

ManualsOnline posted an answer 15 years, 1 month ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Janet posted an answer 15 years ago

4 I figured out how to make it stop. I set it up to brew, with the water, coffee beans in the grinder and the filter in place, while the machine was unplugged. I then made sure the filter door and grinder doors were closed completely shut, as well as the coffee pot inserted completely in place. When I plugged it in.....no beeping and I was able to change the programming time per the manual

Was this answer helpful?

posted an answer 10 years, 6 months ago

3 You can hold the button to right of grinder down with finger if beeping stops, then the arm part of black lid is not coming down far enough to push down the button to telll the machine the lid is closed. On mine I believe a piece came off that was an extension of this arm, to fix could get the correct size screw and screw it into the hole on arm part of the lid adjust it so it will push down the right amount on the button to tell the machine it is closed. Good Luck!

Was this answer helpful?

Janet posted an answer 15 years, 1 month ago

3 I was looking for an answer to this problem too. It has been beeping continuously since we changed the time.

Was this answer helpful?

Lisa posted an answer 14 years, 1 month ago

3 beeps when I plug it in. buttons not working. not making coffee

Was this answer helpful?

Garth posted an answer 8 years, 8 months ago

2 Pull the small black latch above the clock toward you. I've seen most of the moving parts contribute to the beeping (and no grinding) issue. Today, the culprit was the latch (top, front, center) which keeps the main lid on top shut. Even though the lid can seem to be properly shut, the latch has to slide far enough forward to be detected. I oiled it with whatever I had...olive oil. :) this only became an issue for me after using it for a few years. Good luck.

Was this answer helpful?

chrissy posted an answer 12 years, 12 months ago

2 I had taken out the bean grinder component to clean it out while I had some already ground coffee in the basket to brew. It seems the coffee maker won't run unless those parts are in. beeps stopped next time i plugged it in.

Was this answer helpful?

Scott posted an answer 7 years, 10 months ago

0 I found why mine was beeping. The coffee dispenser lock was not fully turned clockwise to lock it into place. Hope that helps.

Was this answer helpful?

Dave posted an answer 6 years, 9 months ago

0 Just to the left and right sides of the coffee hopper lock button are two circles in the plastic which correspond to pegs on the underside of the hopper. When you remove the hopper you will see that each of these pegs indents a small rubber button. The button on the right connects a switch that signals that all is well to proceed with the coffee-grind or no grind. Coffee "dust" can get into the relay and then you get only beeps, but no brew. Just to the rear of the two rubber buttons are plastic "plugs". Pry open the right one, gently, and you can access this relay and hopefully clean the contact.

Was this answer helpful?