AEG 3A Dishwasher User Manual


 
Operating Instructions
25
0 1. Open the door of the dishwasher. The wash programme stops.
2. The indicator for the programme that is currently running extinguishes.
3. Close the door. The wash programme continues.
Cancelling the wash programme
0 1. Press the button for the current wash programme and hold it pressed.
The programme indicator for the current wash programme flashes for a
few seconds and then extinguishes.
2. Release the programme button, the wash programme is cancelled.
3
A selected programme is only interrupted by switching off the dish-
washer, it is not cancelled. The wash programme is continued when the
dishwasher is switched on again.
Setting or Changing the Delay Start Timer
Using the delay start timer you can delay.
Setting the delay start timer:
0 1. Press the ON/OFF button.
2. Keep pressing the DELAY TIMER button b until the number of hours of
delay is flashing on the multi-display.
3. Press the button for the desired wash programme. The multi-display
now displays the number of hours without flashing. The number of
hours is saved.
4. The wash programme starts automatically at the end of the delay set.
Changing the delay start:
As long as the wash programme has not started, you can still change
the delay start set by pressing the DELAY TIMER button b.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower rack, an intelligent electronic system adjusts
the amount of water and the duration of the wash programme to the
number of dishes. By this means it is possible to wash only a few dishes
quickly and economically. At half load (6 place settings), up to 2 litres
of water and 0.2 kWh of electricity are saved.