Filter
Top Products
Operating Instructions
25
...there are problems with the operation of the dish-
washer.
...the wash result is unsatisfactory.
The dishes are still dirty.
– The wrong wash programme was selected.
– The dishes were arranged in such a manner that water has not
reached all parts. The dish racks must not be overloaded.
Malfunction Possible Cause Remedy
The drain pump in the
dishwasher runs con-
tinuously - even with
the appliance switched
off.
The anti-flood system has
been triggered.
Close the tap, then unplug
from the mains and
contact customer service.
The programme does
not start.
The door of the dishwasher is
not closed properly.
Shut the door.
Mains plug is not plugged in. Insert mains plug.
House fuse in defective. Replace fuse.
In the case of dishwasher
models with start delay
timer:
A start delay is selected.
Where dishes are to be
washed immediately, for
appliances
- with multidisplay, set the
delay start to 0.
- without multidisplay, can-
cel the delay start timer.
Rust spots are visible in
the washing compart-
ment.
The washing compartment is
made of corrosion-resistant
stainless steel. Rust spots in
the washing compartment
are from particles from out-
side the appliance (rust par-
ticles from the water pipe,
from pans, cutlery, etc.).
Remove such spots with a
commercially available stain-
less steel cleaner.
Only wash cutlery and dishes
that are suitable for dish-
washer use.
Close the lid of the special
salt container securely.
There is a whistling
noise during washing.
The whistling is not a cause
for concern.
Use a different brand of
detergent.