AEG 4070 Dishwasher User Manual


 
Installation and Connection Instructions
32
If the dishwasher is installed under-
neath a kitchen work surface, the
original work surface of the dish-
washer is to be removed as follows:
– Unscrew the screws (1) from the
elbows on the back side.
– Slide the work surface approx.
1cm to the rear (2)
, lift at the
front
(3) and remove.
– Press the work surface retaining
brackets at the position shown in
the diagram
(4) and remove the
bracket at an angle to the rear
(5).
1
If the dishwasher is later used as a free-standing appliance, the original
work surface must be re-mounted.
3
The plinth on free-standing appliances is not adjustable.
• Free-standing appliances can be
fitted with a décor panel to match
the facings of other kitchen equip-
ment. The décor panels must be
obtained from the kitchen manu-
facturer. A décor frame is necessary
for installation, and can be
obtained as an accessory from the
dealer if not included in the scope
of delivery.
• Decor panel dimensions:
– Height 590 mm
– Width 581 mm
– Clamp thickness: max. 4 mm
To ensure that thin decor panels do not flex or distort, attach them to
the door of the appliance using double sided adhesive tape.
4
5