Operating instructions
33
What to do, when...
Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...a flashing fault code appears
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by an intermittent audible
signal and, if your appliance is equipped with an optical floor signal, in
the event of an error a dot-shaped optical signal will flash on the
floor: open the dishwasher door, a fault code is visible in the digital
display (see following chart).
Carry out the following suggested corrective actions.
Fault code / Malfunction
in the digital display
appears
The machine does not fill
with water
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean out the sink spigot.The sink spigot is blocked.
Check the water drain
hose connection.
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
The water inlet hose has not
been correctly laid or it is
bent or squashed.
Check the water inlet hose
connection.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Possible cause Solutions
in the digital display
appears
The dishwasher will not
drain
Close the water tap and
contact your local Service
Force Centre.
Protection against flooding is
active.
in the digital display
appears
Once the checks have been carried out, to continue the programme
press the button of the programme that was running before the
intervention of the alarm and close the door. The programme will
continue from the point in which it was interrupted. If the fault code
reappears contact your local Service Force Centre.
For other combinations of fault codes not described in the above chart
will appear, please contact your local Service Force Centre.
152963040en per uk.qxp 25/03/2004 15.37 Pagina 33