Filter
Top Products
4
B - Cooking Instructions
Automatic start-up without valves
Turn the corresponding knob anti-clockwise up to the maximum position (Large flame, Fig. 1) and press
start-up button (fig. 1).
Automatic start-up with valves
Turn the corresponding knob anticlockwise up to the maximum position (large flame, fig. 1) and press the
knob. Once the burner has been started up, keep the knob pressed for about 6 seconds.
Using the burners
In order to obtain the maximum yield without wasting gas, it is important that the diameter of the pot is
suitable for the burner potential (see the following table). This is to avoid the flame extremities being
larger than the base of the pot.
All of the operating positions must be chosen between the maximum and the minimum ones, never
between the minimum position and the closing point.
The gas supply can be interrupted by turning the knob clockwise up to the closing position.
NOTE: If there is no power supply, it is possible to light the burners with matches, setting the knob
to the start-up point (large flame, fig. 1).
BURNERS POWER POWER
(MJ/h) (Btu/h) Ø Of Pots
Auxiliary 3.6 3415 10 - 14 cm
Semi-rapid 6.3 5976 16 - 18 cm
Rapid 10.8 10245 20 - 22 cm
Wok 13.7 12977 24 - 26 cm
NOTE: When the equipment is switch off, always check that the knobs are in the closing position.
If the flame should blow out accidentally, the safety valve will automatically stop the gas supply, after a
few seconds. To restore operation, set the knob to the lighting point (large flame, fig. 1) and press. While
cooking with fat or oil, pay the utmost attention as these substances can catch fire when overheated.
WARNING:
• Do not use sprays near the appliance in operation.
• Do not place unstable or deformed pots on the burner, so as to prevent them from overturning or
overflowing.
• Always turn gas off if moving a pot away from the appliance.