Filter
Top Products
Operating Instructions
26
Starting the Wash Programme
0 1. Check that the dishes and cutlery are loaded into the dishwasher in
such a manner that the spray arms are free to rotate.
2. Open the tap fully.
3. Shut the door.
4. Press the ON/OFF switch The ON/OFF switch indicator illuminates.
5. Press the button for the programme required (see “Programme Table“).
The programme indicator and the associated wash programme steps in
the programme progress display illuminate. After around 6 seconds, the
wash programme selected starts. The remaining time for the pro-
gramme calculated from quantity of dishes loaded is displayed in the
multi-display. With automatic programme adjustment this residual
time count can be stopped or corrected if necessary (load quantity,
degree of dirtiness, etc.) using the dishwasher control. The current pro-
gramme step is also displayed in the programme progress display.
3
If fault messages are displayed on the multi-display after the start of
the programme, please read the “What to do, if...“ section.
Changing/Interrupting/Cancelling the Wash Pro-
gramme
3
Only change or interrupt a wash programme in progress if it is abso-
lutely necessary. When the appliance is closed again, the air that has
entered is heated rapidly and expands. This can cause water to escape
onto the floor and possibly trigger the anti-flood system.
Changing the wash programme
3
If you want to change the wash programme within the first 6 seconds
after the selection of the programme, briefly press the button for the
required programme.
If you want to change the wash programme at a later point in time, use
the following procedure:
0 1. Press the button for the new wash programme and keep it pressed. The
indicators for both wash programmes now flash.
2. After a few seconds, only the display for the new wash programme
flashes. Release the programme button, from now on the new wash
programme is carried out.