AEG AGN2451 Freezer User Manual


 
Problem Possible cause Solution
The door is not closed correctly. Refer to "Door open alarm".
upper or lower square
is shown in the tempera-
ture display.
An error has occurred in meas-
uring the temperature.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
“dEMo” appears on the
display.
The appliance is in demonstra-
tion mode.
Keep pressed approximately 10
sec the OK button since a long
sound of buzzer is heard and the
display shut off for a short while:
appliance start works regularly.
The compressor runs con-
tinuously.
The Temperature regulator may
be set incorrectly.
Set a warmer temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently.
Do not keep the door open longer
than necessary.
The food temperature is too
high.
Let the food temperature de-
crease to room temperature be-
fore storage.
The room temperature is too
high.
Decrease the room temperature.
There is too much frost
and ice.
The door is not closed correctly. Refer to "Closing the door".
The door gasket is deformed or
dirty.
Refer to "Closing the door".
The temperature in the
appliance is too cold.
The Temperature regulator may
be set incorrectly.
Set a warmer temperature.
The temperature in the
appliance is too warm.
The Temperature regulator may
be set incorrectly.
Set a colder temperature.
The door is not closed correctly. Refer to "Closing the door".
The food temperature is too
high.
Let the food temperature de-
crease to room temperature be-
fore storage.
The temperature in the
freezer is too warm.
Food is too near to each other. Store food so that there is cold
air circulation.
Large quantities of food to be
frozen were put in at the same
time.
Insert smaller quantities of food
to be frozen at the same time.
The appliance does not
operate.
The appliance is switched off. Switch on the appliance.
The mains plug is not connected
to the mains socket correctly.
Connect the mains plug to the
mains socket correctly.
14 What to do if…