Filter
Top Products
12
Die Schiene (A) auf der Innensei-
te der Möbeltür oben und unten
auflegen (siehe Abb.) und die
Position der Bohrlöcher anzeich-
nen. Nachdem die Löcher
gebohrt wurden, die Schiene mit
den mitgelieferten Schrauben
befestigen.
20 mm
A
50mm
PR166
Gerätetür und Möbeltür auf ca.
90° öffnen. Den Winkel (B) in der
Schiene (A) einsetzen. Gerätetür
und Möbeltür zusammenhalten
und die Bohrlöcher anzeichnen
(siehe Abb.). Winkel abnehmen
und die Bohrlöcher mit Ø 2mm
und einem Abstand von 8 mm
von der Türaußenkante bohren.
Den Winkel wieder auf der
Schiene anbringen und mit den
mitgelieferten Schrauben befe-
stigen.
Die Abdeckung (C) in die Schiene
(A) eindrücken, bis sie einrastet.
PR33
C
A
8mm
PR167
A
B
37
Interior Accessories
Storage Shelves
The glass shelf above the fruit and
vegetable compartment should
always remain in position, to ensure
fruit and vegetables stay fresh lon-
ger.
The remaining storage shelves can be
adjusted to various heights:
Pull the storage shelf forward until it
can be tipped up or down and remo-
ved.
To insert at a different height use the same procedure in reverse.
Adjustment for tall goods:
Remove the front half of the two-part vario glass storage shelf and insert it
at a different level. Space is thus gained for storage of tall goods on the
underlying storage shelf.
Variable Inner Door
The door compartments can be pulled up and removed, and inserted at
other positions as needed.
Moisture regulator
There is an adjustable air grille in front of the shelf above the fruit and vege-
table compartments.
D338
The temperatures in the refrigerator compartment and freezer co partment
cannot be independently regulated.
If you want the freeze fresh food rapidly, select setting „6“, ensuring that
the temperature in the refrigerator compartment does not drop blow 0°C.
You should also promptly reset the temperature regulator to setting „3“ or
„4“.
Important!
High ambient temperatures (e.g. on hot summer days) and a cold setting on
the temperature regulator (position"5" to "6") can cause the compressor to
run continuously.
If this happens, turn the temperature regulator back to a warmer setting
(position "3" to "4"). At this setting the compressor will be switched on and
off as usual and automatic defrosting recommenced.