Filter
Top Products
81
180°
A
B
C-OK!
Fig. 8
Wall unit mounting - Fig. 8-9
Pre-mounting operations (Only for
model DD 8625-8821)
First decide which functioning version is
better for you.
If you decide to use the hood in
exhausting version we suggest to position
the upper section of the chimney so that
the oulet slots are not visible once
installation has ended, on the contrary if
is decided to use the hood in recycling
version BE SURE that the side with slots
is up (see also A-B-C sequence on on
Fig. 8).
Mark the wall with a centre line, this will
aid mounting procedure (1), position the template so that the mid
line printed on the template matches with the centre line previously
drawn, the lower side of the template corresponds to the lower side
of the hood once mounted (2).
Drill two holes Ø 8mm and fix the support bracket with two wall
plugs and screws (3). Hang the hood (4) and adjust its position (5-
6).
From the inside of the hood sign two points for definitive fixing (7).
Remove the hood (8) and drill two holes Ø 8mm (9), fit two wall
plugs (10).
Drill two holes Ø 8mm on the upper side close to the ceilling, fit two
wall plugs (11) (In case the hood is to be used in filter version,
mount the deflector F on the chimney support with 2 screws) and fix
the chimney support G with two screws (12).
Hang the hood again (13) and fix it definitively with two screws (14).
Fit an exhausting pipe (15) to connect the outlet hole B of the hood
to the outside (Extractor hood) or to the deflector F (Filter version).
Make electrical connection (16).
Fix the chimney first up (17a) to the chimney support (17b), then
slide the lower section of the chimney down into the proper housing
on top of the hood (18).
Only for model DD 8625-8821: Fix the lower section to the hood
with two screws (19).