Filter
Top Products
80
Fig. 8
Wall mounting - Fig. 8
Mark a centre line on the wall (1).
Fix the drilling template to the wall (2).
Make 3 Ø 8mm holes in the wall (3), 2 at upper points, 1 as desired
at lower points.
Insert the three Ø 8mm expansion plugs into the wall (4).
Insert 2 5x45 screws (5) but do not tighten them completely, hang the
hood (6).
Only DU 4161 - DU 4361 - DU 4561: Adjust the unit so that it is
positioned at a right angle to the wall by turning the two screws on
lower side (7).
Tighten the 2 upper screws (8).
From inside the hood, insert the third 5x45 screw into the lower hole
(9) and tighten (10).
2
3
4
4
4
5
5
3
1
6
6
9
8
1cm
5
!
10
8
7
7