Filter
Top Products
g
9
Assembling the juice extractor
Before first use, the appliance parts
should be cleaned (section on “Dis-
mantling and cleaning”).
0 Place the appliance on a flat, dry work
surface.
Unwanted flex can be inserted into the
flex compartment (Fig. 1/12).
0 Arrange the motor part in an upright
position so that the knob at the front
faces you.
0 Place the juice bowl with the juice out-
let on the LH side of the motor part
(Fig. 2).
0 Place the strainer basket in the juice
bowl (Fig. 3).
0 Place the upper part with the juice
outlet on the LH side (Fig. 4).
0 Engage and press down the locking
clips (Fig. 5).
0 Push the residue container in properly,
so that it engages (Fig. 6).
0 Place the container supplied or anoth-
er suitable vessel underneath the juice
outlet (Fig. 7).
0 Position the plunger.
Safety system
The appliance can only be switched on,
if all parts of the appliance are pro-
perly assembled and joined together.
• The juice bowl must be properly
inserted (Fig. 2).
• The locking clips must be properly
locked (Fig. 5).
• The residue container must be properly
inserted, so that it engages (Fig. 6).
Operate the appliance as follows:
For soft fruit
and vegetables =
Knob to the right
For firm fruit
and vegetables =
Knob to the left
To switch off the juice extractor, turn
the knob to “0”.
Juice extraction
Fill the appliance with the prepared,
chopped fruit or vegetables and lightly
press down with the plunger. Smaller
pieces can be shaken down on to the
surface of the filling bowl. With the
plunger, move the fruit or vegetables
towards the filling shaft. When filling
fruit containing pips (e.g. grapes, to-
matoes), hold the plunger when reple-
nishing so that it always evenly covers
the filling opening. When re-applying
the plunger, make sure that the motor
is not too strongly retarded. Make sure
that the full residue container is
promptly emptied. Please check that
the strainer basket is free from obs-
truction. When the juice has been ex-
tracted from the last piece, the motor
must run until juice ceases to drip.
Dismantling and cleaning
Important note! The appliance should
only be dismantled when the motor
has been switched off and the applian-
ce unplugged.
0 Take out the plunger, remove the resi-
due container.
0 Unclip both locking clips und lift off
the upper part.
0 The strainer basket and juice bowl are
removed from the motor base together.
Wipe the motor part only with a damp
cloth! Clean all other parts in hot wa-
ter or in normal washing-up water! The
sooner this happens after appliance
use, the more easily will cleaning pro-
ceed! Use a brush to clean the strainer
basket and groove in the upper part.
Please treat the appliance gently. Never
scratch or scour it. Any possible discol-
orations (e. g. due to carrots or beet-
root) can be rubbed off with vegetable
oil.
Do not clean in the dishwasher the
motor part, upper housing and plunger.
Never immerse the appliance in water!
ESF103_neu_de.book Seite 9 Montag, 15. Dezember 2003 2:46 14