Filter
Top Products
Installation
10
Levelling
The appliance must be level. Level the
appliance by adjusting the two
adjustable feet (1) at the front of the
appliance.
If required the washer (2) can be
removed.
Reversing the Door
The side at which the door opens can be changed from the right side (as
supplied) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appliance
must not be connected to the mains. Remove plug from the mains
beforehand.
Carefully tilt the appliance to the back and place an adequate object under
it.
Take care to avoid the compressor
or the condenser touching the
ground.
Unscrew both adjustable legs at
the front.
Dismount the door holder at the
bottom on the right side. For this,
drive the three screws out, and
pull the door holder down
together with the door holder
pin. Remove the screw on the left
side, and drive it in on the right
side.
Remove the door by pulling it
downwards while keeping it
slightly opened.
Unscrew the upper door holder,
and screw it in on the opposite
side.
2
1