Filter
Top Products
25
If something does not work
During operation of the appliance some smaller but annoying trouble can
often occur, which does not require calling a technician out. In the following
chart information is given about them to avoid unnecessary charges on serv-
ice.
We draw your attention that operation of appliance goes with certain sounds
(compressor- and circulating sound). This does not necessarily mean a fault
has occurred, this goes together with the operation of the appliance.
We draw it to your attention again that the appliance operates discontinu-
ously, so the stopping of compressor does not mean being no-current. That
is why you must not touch the electrical parts of the appliance before break-
ing the circuit.
Problem
It is too warm in the
refrigerator.
It is too warm in the
freezer.
Water flows at the
back plate in the
refrigerator.
Water flows into the
chamber.
Water flows onto the
floor.
There are too much
frost and ice.
Possible cause
Thermostatic control can be set incor-
rectly.
If products are not cold enough or
placed incorrectly.
The door does not close tightly or it is
not shut properly.
Thermostatic control can be set incor-
rectly.
The door does not close tightly or it is
not shut properly.
Products in big quantity to be frozen
were put in.
Products to be frozen are placed too
closely to each other.
It is normal. During automatic defrost-
ing frost melts on the back plate.
The outlet of the chamber can be
clogged up.
Products placed in can prevent water
from flowing into the collector.
The melting water outlet flows not
into the evaporative tray above the
compressor.
Products are not wrapped properly.
Doors are not shut properly or do not
close tightly.
The thermostatic control can be set
incorrectly.
Solution
Set the thermostat knob to higher
position.
Place the products according to the
chapter „Storing in the refrigerator”.
Check if the door closes well and the
gasket is unhurt and clean.
Set the thermostat knob to higher
position.
Check if the door closes well and the
gasket is unhurt and clean.
Wait some hours and then check the
temperature again.
Place the products in a way so that
cold air could circulate among them.
Clean the outlet.
Replace the products so that they can
not touch the back plate directly.
Put the melting water outlet to the
evaporative tray.
Wrap the products better.
Check if the doors close well and the
gaskets are unhurt and clean.
Set the thermostat knob to a position
that gives higher temperature.