Filter
Top Products
FREQUENTLY ASKED QUESTIONS
What grind should I use? We recommend
using "fine drip" grind. If you use a blade grinder,
run it for 20 to 30 seconds. For single-scoop
pressings, you can even use espresso grind.
Using a fine grind helps brew very rich flavor.
Why do you recommend brewing with 175°F
(80°C) water? All of our tasters, from coffee
lovers to coffee professionals, preferred 175°F.
It delivers a smooth, rich brew. Hotter water
increases bitterness and acidity.
How do I heat water to the right temperature?
Microwave oven: Use a thermometer and
experiment to determine the time needed to
heat the desired amount of water to 175°F.
In the future, heat the same amount of water
for that time.
Kettle: Poke a thermometer in the spout
of your kettle and heat until it reads 175°F.
Three-quarters of the time to boil: Heat
the desired amount of water in a kettle or
microwave oven and measure the time it
takes to boil. Heating the same amount of
water for three-quarters of that time will
reach the right temperature.
Instant hot water:
If you have instant hot
water in your kitchen, it's probably close to 175°.
If necessary, take a few minutes to set it.
Some water drips through the coffee and
filter before I stir. Is that OK? That is
perfectly normal and will not affect the final brew.
If a lot of water runs through before stirring,
remember to use fine-drip grind and to pour
the water in slowly, particularly for the first few
seconds to wet the grounds.
Am I doing something wrong if it is hard
to press? Pressing hard compresses the
puck of coffee and blocks the flow. Gentle is
the key. Gently press the plunger down about
a quarter inch and then maintain that amount
of pressure as the plunger sinks down to the
grounds. Let the air pressure in the chamber
do the work. If you press gently and pressing
is still difficult, try a coarser grind.
If I am just making a single cup, can I push
all the water for the cup through the press?
Yes, but when you push a full cup of water past
the grounds it extracts bitterness. Diluting your
espresso-sized pressing with hot water makes
a much smoother brew.
How do I make a latte? A latte is espresso
mixed with hot milk. You can add hot milk to the
espresso or you can add cold milk and then heat
the latte in a microwave oven.
How do I make a cappuccino?
Cappuccino is simply espresso capped with a
layer of foamed milk. The traditional way of
foaming and heating milk is with steam. But
those who have tried battery powered stirrers
agree that they do a great job of foaming milk
and are very easy to use and clean.
Can I clean the AeroPress in the dishwasher?
You can in the top shelf, but a simple rinse is
entirely sufficient because the plunger wipes
the chamber clean.
Where do I get more AeroPress filters?
Most AeroPress retailers also sell replacement
filters. For a list of retailers that sell filters,
visit www.aerobie.com.
What if I need a part?
Contact the distributor in you rcountry listed at
www.aerobie.com or call Aerobie, Inc. at
1-650-493-3050 to order replacement parts.
HINTS
You can press using from 1 to 4 scoops of
grounds. Each AeroPress scoop makes a
single espresso or 5 ounces of American coffee.
Fill the chamber with hot water to the number
corresponding to the number of scoops.
You can make a full carafe of coffee
using your AeroPress in less time
than it takes to brew a pot of drip
coffee. Two 3-scoop or 4-scoop
pressings, topped off with hot water
will fill most
vacuum carafes.
If you grind your own, use the AeroPress
funnel to transfer the coffee from the grinder
to the AeroPress chamber. A scoop of beans
equals a scoop of grounds.
If pressing is too difficult
, try pressing more
gently and/or using
a coarser grind. For
single-scoop pressings you can use the
finest grind you can get.
The plunger can be used to measure water.
Two thousand filters use about as much paper as
one city newspaper, so you needn't feel guilty
about discarding filters. But you can also re-use
each filter many times just by brushing it off
under running water. The choice is up to you.
When re-using a filter, remove the plunger and
twist the cap containing the wet filter onto the
chamber. This will keep it flat as it dries and
you'll be ready for the next pressing.
AeroPress is a registered trademark of Aerobie, Inc.,
Palo Alto, California, U.S.A.
April 2011 Aerobie, Inc. All rights reserved.