Filter
Top Products
Installation
All specifications and product design subject to change without notice.
Such revisions do not entitle the buyer to corresponding changes, improvements,
additions, replacements or compensation for previously purchased products.
3
Cabinet Clearance
Ventilation is required for the bottom front section of the
unit where the grille is located. Keep this area open and
clear of any obstructions.
Adjacent cabinets and countertop can be built around the
unit as long as no top trim or countertop is installed lower
than the top of the hinge. Make certain that the glides
supplied with the ice machine are installed according to
instructions. Make certain your ice machine is level.
Leveling adjustments can be made by raising or lowering
the glides on the bottom of the unit.
Electrical Connection
Check the serial nameplate for the correct power supply.
Use only the electrical power supply specified on the serial
nameplate. Do not use an extension cord.
Grounding Method
This ice machine is equipped with a power supply cord
with ground. It must be plugged into a mating grounding
type receptacle in accordance with the National Electrical
Code and applicable local codes and ordinances.
Ideal Ambient Temperature Range*
built-in
freestanding
55-80°F
55-90°F
* Ice Machine will not perform correctly in ambient temperatures less than 55°F.
THIS UNIT SHOULD NOT, UNDER ANY CIRCUM-
STANCES, BE UNGROUNDED.
DISCONNECT POWER SOURCE BEFORE
ADJUSTING LEVELING LEGS
Select Location
The proper location will ensure peak performance of your ice
machine. Choose a location away from heat and out of
direct sunlight. Best performance will be maintained when
installed within the following parameters: