Filter
Top Products
SECTION 6
Completing the Installation
1. Reinstall the fan’s venturi by holding it at approximately a 45
degree angle, hook the two tabs on the venturi into the slots
on the housing and secure in place by tightening the venturi
screw. Rotate the blower wheel by hand to ensure it spins
freely. Now plug the fan motor into the receptacle (Figure 11).
2. Plug cord from lamp holders into the appropriate receptacle
(Figure 12).
3. Reinstall the light reflector by securing in place on the mounting
bolt with the flat washer then the reflector, two lock washers
and reflector nut. Tighten nut fully (Figure 13).
CAUTION: FAILURE TO SECURE THE REFLECTOR BOLT MAY
RESULT IN A RATTLING OR HUMMING NOISE.
4. Install a 100 watt maximum, type A19 medium base
incandescent bulb (not included).
CAUTION: WHEN INSTALLING GRILL, BE CARFUL NOT TO
PINCH FINGERS BETWEEN GRILL AND CEILING.
5. Install the grill by squeezing the two ends of the springs
together and installing them up into the slots on the fan’s
housing. Push the grill up into position (Figure 14).
www.airkinglimited.com
210572097 Rev. A 8-05 4 of 12
6. Restore power and test your installation.
SECTION 7
Use and Care
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE SERVICING THE UNIT.
1. Cleaning the Grill: Remove grill and use a mild detergent,
such as dishwashing liquid, and dry with a soft cloth. NEVER
USE ANY ABRASIVE PADS OR SCOURING POWDERS.
Completely dry grill before reinstalling. Refer to instructions
in Section 6
Completing the Installation
, to reinstall grill.
2. Cleaning the Fan Assembly: Wipe all parts with a dry cloth
or gently vacuum the fan. NEVER IMMERSE ELECTRICAL
PARTS IN WATER. Refer to instructions in Section 6
Completing the Installation
, to reinstall venturi.
CAUTION: ALLOW BULB TO COOL BEFORE REPLACING
3. Changing the Light Bulb: Disconnect power to the unit.
Remove grill by pulling downward on grill and squeezing grill
springs together to release from housing (Figure 15). Remove
light bulb and refer to instructions in Section 6
Completing
the Installation
, to complete the light bulb change and
installation of grill.
Figure 11
Figure 12
Figure 13
Flat Washer
Reflector
Lock Washers
Nut
Figure 15
Figure 14