Filter
Top Products
2. Using 8 of the included 8-32 screws and washers, mount the
blower in place and tighten all screws. Confirm that the blower
is securely seated in place and there are no air gaps around
the blower gasket.
3. Plug the 3 wire quick connect cord from the blower into the
receptacle on the range hood canopy. Plug the 4 wire quick
connect cord from the blower into the one end of the wiring
harness then connect the other end of the wiring harness to
the receptacle in the range hood canopy. These cords will
only fit into the receptacles one way (Figure 3).
SECTION 3
Installation into 10" High Canopy
1. Remove the rear bottom plate of the hood canopy. It is secured
in place with a screw and washer on either side (Figure 4).
2. Lift blower up into the hood canopy and slide the keyhole
slots in the blower mounting flange over the two studs of the
hood. Slide the blower into place and tighten the hex nuts on
the mounting stud while lining up the 8 holes in the blower
mounting flange to the 8 screw studs of the hood (Figure 2).
www.airkinglimited.com
111597002 Rev. A 9-07
2 of 12
Figure 2
Keyholes
Stud w/Hex Nuts
Screw Stud
INSTALLATION INSTRUCTIONS
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE STARTING INSTALLATION.
WARNING: THIS BLOWER IS INTENDED FOR USE ONLY
IN AIR KING PROFESSIONAL SERIES RANGEHOOD CANOPIES
MARKED SUITABLE FOR USE WITH THIS BLOWER. DO NOT TO
INSTALL IN ANY OTHER APPLICATION.
SECTION 1
Preparing for installation
NOTE: Before installing blower, make sure range hood canopy is
properly installed and securely in place. See “Range Hood
Mounting Instructions”.
1. Unpack blower from the carton and confirm that all pieces
are present. In addition to the blower you should have:
8 - 8-32 Screws
8 - Washers
1 - Fuse
1 - Wire Harness
1 - Capcitor Cover
3 - #6 Screws
1 - Instruction/Safety Sheet
2. Position capacitor attached to motor over center mounting
hole in face of blower and fasten in place using (1) # 6 screw.
Position the capacitor cover over the capacitor and fasten
in place using (2) # 6 screws (Figure 1).
3. The installation of the blower is slightly different from one
canopy height to another. For 18" high canopies proceed to
Section 2, for 10" high canopies proceed to Section 3.
SECTION 2
Installation into 18" High Canopy
1. Lift blower up into the hood canopy and slide the keyhole
slots in the blower mounting flange over the two studs of the
hood. Slide the blower into place and tighten the hex nuts on
the mounting stud while lining up the 8 holes in the blower
mounting flange to the 8 screw studs of the hood (Figure 2).
Receptacles
Figure 3
Blower
Wire
Harness
Figure 4
Screw
Bottom Plate
Washer
Figure 1
Capacitor