Filter
Top Products
EN
24
Data is collected and displayed approximately every
60 seconds.
VIEW TEMPERATURE AND HUMIDITY AREA
Press SEL to navigate to the Temperature and Humidity
Areas.
Temperature data is given at the top; Humidity is
below.
SELECT MEASUREMENT UNIT
Slide the °C / °F switch (inside the clock battery
compartment), to the setting you want.
SELECT SENSOR CHANNEL
Press CH to switch between sensors 1-5.
The house icon shows the selected remote sensor.
• To auto-scan between sensors, press and hold CH
for 2 seconds. Each sensor’s data will be displayed
for 3 seconds.
• To end auto-scan, press CH or MEM with the
Temperature / Humidity Area selected.
NOTE
If you select a sensor that collects only
temperature data, the humidity will not be shown.
MINIMUM / MAXIMUM RECORDS
• Press MEM repeatedly to view current, maximum and
minimum records for the selected sensor.
• To clear the records, press and hold MEM for 2
seconds. A beep will sound to confirm that the memory
has been cleared.
TEMPERATURE AND HUMIDITY TREND
The trend lines are shown next to the temperature and
humidity readings.
TREND RISING STEADY FALLING
TEMPERATUR
E
HUMIDITY
BAR916HG_EN_OP.indd 24 5/8/06 11:24:30 AM