Filter
Top Products
28-EN
Convenient Functions
Storing settings in the memory
This function can store up to 6 adjustments/
settings.
The following adjustments/settings are stored in
a preset memory. For more details, see each
page for the below items.
Page 4: Speakers Setting / Pages 6 - 11: Time
Correction/Phase Switching/Bass Focus Setting /
Pages 12 - 14: Equalizer Adjustment / Pages 15 -
17: X OVER Adjustment / Pages 18 - 19: MX
Settings / Page 19: BASS COMP. Setting / Page
20: Pro Logic II Mode Setting/Center Width
Adjustment* / Pages 21 - 25: Dolby Surround
adjustment* / Page 26: Linear PCM Setting*
*Depending on the signal input, there is no
effect.
1 Make the adjustment or setting you want to store
in the memory.
2 Press and hold any button from 1 to 6 for at least
2 seconds to store the setting into preset
memory (“MEMORY1” to “MEMORY6”).
NOTES
• This operation can only be performed when the
defeat mode is turned off.
• The stored contents will not be deleted even when the
battery power cord is detached.
Calling out stored values
1 Press any button from 1 to 6 to select the preset
memory you want to call out (“MEMORY1” to
“MEMORY6”).
In the preset memory, numerous settings/
adjustments are stored. Therefore, it may take
some time to access the stored preset memory.
NOTE
This operation can only be performed when the defeat
mode is turned off.
Defeat mode
1 Press the DEFEAT button.
All properties are made flat.
2 Press the DEFEAT button again to cancel.
NOTES
• The “Parametric EQ”, “Graphic EQ”, “AUTO
TCR”, “TCR/phase switching”, “MX”, “X-OVER”
and “BASS COMP. setting” operations cannot be
performed when the defeat mode is turned on.
• To protect the speakers, the “X-OVER” setting does
not change.
DEFEAT
1~6
DISP
SAV
E
T
O
RY 2
M
E
M
PRESE
L
O
AING
D
T
O
RY 1
M
E
M
PRESE
DEFEAT
O
N