Filter
Top Products
Before operating the unit, clean both the interior and
exterior of the unit with a clean, damp cloth and mild
soap solution. Rinse carefully. Clean and install the
shelf slides and shelves.
Become familiar with the operation of the controls.
Read this manual and keep it in a secure location.
The appliance is equipped with a special heating cable.
Through this Halo Heat concept, the heating cable is
mounted against the walls of the unit to provide an
evenly applied heat source controlled by a thermostat.
The design and operational characteristics of the unit
eliminate the need for a moisture pan or a heat
circulating fan. Through even heat application,
the quality of food products is maintained up to several
hours or more.
S TA R T- U P. . . .
1. Connect the electric cord to an appropriate
power outlet.
2. Close the compartment vents located on the
inside of each compartment door.
3. Press the power ON for the appropriate
compartments. The power button will illuminate.
4. Rotate the control knob to the desired holding
temperature. The temperature will be displayed
on the digital display.
5. The temperature display light will illuminate
when the inside air reaches the desired holding
temperature.
TO TOGGLE BETWEEN FAHRENHEIT
AND CELSIUS
The factory default is Fahrenheit. To change to
Celsius:
1. With the control OFF (i.e. temperature setting in
the OFF position), press and hold the Temperature
Display button for 5 seconds.
2. The control will show “degC” for 3 seconds to
verify selection and then show the temperature.
(Set Point or Actual, whichever the user has
selected) in ºC.
3. Repeat to toggle to Fahrenheit.
Note: With a power failure, factory test, etc., the control
will retain the ºC or ºF setting selected by the user when
power is restored.
7
O P E R A T I O N
S TA R T- U P
I
o
I
o
On/Off
Power
Switch
Digital
Display
Temperature
Control Knob
Temp
Display
Light