Alto-Shaam 100-HW/D643 Food Warmer User Manual


 
Hot Food Drop-In Well Operation & Care Manual • 4
INSTALLATION
1. An identification tag is permanently mounted
on the appliance.
2. This appliance is equipped with a three-prong
grounding plug. For your protection against
shock hazard this appliance should be plugged
directly into a properly grounded three-
prong receptacle. Do not cut or remove the
grounding prong from this plug. Plug the unit
into a properly grounded receptacle ONLY,
positioning the unit so that the plug is easily
accessible in case of an emergency. Arcing
will occur when connecting or disconnecting
the unit unless all controls are in the “OFF”
position.
3. Proper receptacle or outlet configuration or
permanent wiring for this unit must be
installed by a licensed electrician in
accordance with applicable local
electrical codes.
ELECTRICAL CONNECTION
DANGER
ENSURE POWER SOURCE
MATCHES VOLTAGE STAMPED
ON APPLIANCE NAMEPLATE.
DANGER
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
DANGER
To avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code ANSI/
NFPA No. 70. In Canada, all electrical
connections are to be made in
accordance with CSA C22.1, Canadian
Electrical Code Part 1 or local codes.
For CE approved units: To prevent an electrical
shock hazard between the appliance and other
appliances or metal parts in close vicinity, an
equalization-bonding stud is provided. An
equalization bonding lead must be connected to
this stud and the other appliances / metal parts
to provide sufficient protection against potential
difference. The terminal is marked
with the following symbol.
NOTE: CE approved appliances must be
connected to an electrical circuit that is
protected by an external GFCI outlet.