Filter
Top Products
767-SK/III, 1767-SK/III, 2800-SK/III INSTALLATION/OPERATION/SERVICE MANUAL PG. 15
O P E R A T I N G I N S T R U C T I O N S
Preset Menu Keys:
T
his Alto-Shaam oven allows the operator to set up to eight cook/smoke programs. Each program can be
preset in any program mode to cook/smoke by time or internal product temperature. Programs are recalled
and stored using the P
RESET Keys labeled "A through H." These keys, along with the key labeled "I", share
additional functions described in the "User Options" section of this manual.
Programming a Cook/Smoke Program
Select the product to be programmed and begin programming with the oven control power
OFF. Press and release control ON/OFF key. The oven will beep for one second and power
to the unit will be indicated by an illuminated green indicator light located in the upper left
corner of the ON/OFF key. The oven will begin operating in the hold mode. The amber
HOLD indicator will be illuminated and the last set hold temperature will be displayed.
Press HO
LD
Key. To change the hold temperature, press the UP or DO
WN
AR
ROW
Key.
Press CO
OK
Key. Oven preheat indicator will illuminate and the last set cooking temperature
is displayed. To change the cook temperature, press the UP or DOWN ARROW Keys.
To cook by time — press the TIME Key. Last set cooking time is displayed.
To change the set time, press the UP or DOWN ARROW Key. The green TIME indicator will illuminate.
To cook by probe — press the PROBE Key. Last set internal product temperature is displayed.
To change the set temperature, press the UP or DOWN ARROW Key. The green PROBE
indicator will illuminate.
Press SMOKER Key. To set the smoke time desired, use UP or DOWN ARROW key. The last set
time will be displayed.
The oven preheat indicator will illuminate. Oven is now in the preheat mode and is
automatically programmed to preheat to the cook temperature.
Select a letter code for the product programmed by the previous steps. Press and hold the selected
PRESET key until you hear a brief, four second beep. The letter key program indicator light will
illuminate and the product programmed is now stored in memory for the specific letter key pressed.
Additional programs can be stored in the remaining PRESET Keys if not previously programmed.
Note: The last PRESET Key used will be the oven cooking run sequence for the next product
to be programmed. Settings can be manually changed for the next product and an alternate
pre-programmed letter key selected.
Erasing a Cook/Smoke Program
To erase a program, the oven must be in either the power-up hold mode or in the preheat mode. The oven
cannot be running a PRESET Menu program.
When the oven is in the power-up hold mode or in the preheat mode, press and hold both the CANCEL Key and
the appropriate letter PRESET Key to be erased. The oven will beep in approximately four seconds and the
program's indicator light will go out to indicate the program has been erased.
IMPORTANT - After programming a specific product into memory in a programmable
preset key, it is very important to make a written permanent record of the product and
the program letter assigned. Menu card (PE-23384) is provided for this purpose.
— or —
PRESETS
A