Alto-Shaam 300-HW/D443 Food Warmer User Manual


 
The Alto-Shaam appliance
must be installed in a
location that will permit
the unit to function for its
intended purpose and
to allow for proper
cleaning, and maintenance.
1. The appliance must be installed on a stable and
level surface. A non-combustible, heat resistant
surface is highly recommended.
2. DO NOT install this appliance in any area where
it may be affected by any adverse conditions
such as steam, grease, dripping water, high
temperatures, etc.
3. The outer walls of the hot well can reach 200°F
(93°C) to 260°F (127°C). Verify countertop material
temperature rating with manufacturer before
installing to ensure counter can withstand heat.
LEVELING
The heated well
should be leveled before the
electrical supply is connected. Level the appliance
from side-to-side and front-to-back with the use of
a spirit level. For appliances installed on a mobile
stand, it is important that the floor surface be level
due to the probability of frequent repositioning.
NOTE
It is important to apply a food grade silicone
underneath the decor flange to seal flange to the
countertop.
ROUGH CUT COUNTER TOP OPENING
model 100-HW/D4 or D6 one pan: 14-1/4" x 22-3/4" (362mm x 578mm)
model 100-HW/D443 or D643 one & one-thrid pan: 14-1/4" x 29-3/4" (362mm x 756mm)
model 200-HW/D4 or D6 two pan: 22-3/4" x 27" (686mm x 563mm)
model 300-HW/D4 or D6 three pan: 40" x 22-3/4" (1016mm x 578mm)
model 300-HW/D443 or D643 three & one-third pan: 40" x 29-3/4" (1016mm x 756mm)
model 400-HW/D4 or D6 four pan: 53-1/8" x 22-3/4" (1350mm x 578mm)
model 500-HW/D4 or D6 five pan: 66-1/4" x 22-3/4" (1683mm x 578mm)
Hot Food Drop-In Well Operation & Care Manual • 3
INSTALLATION
®
DANGER
IMPROPER INSTALLATION,
ALTERATION, ADJUSTMENT,
SERVICE, OR MAINTENANCE COULD
RESULT IN SEVERE INJURY, DEATH,
OR CAUSE PROPERTY DAMAGE.
READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR SERVICING
THIS EQUIPMENT.
CAUTION
TO PREVENT PERSONAL INJURY,
USE CAUTION WHEN MOVING OR
LEVELING THIS APPLIANCE.
OPTIONS AND ACCESSORIES
pan divider bars
hw series full-size 16019
300-hw/d443 & d643 full-size 1011928
hw series half-size / third-size 11318