Filter
Top Products
MN-29758(Rev.4)•TH/III&SK/IIIINSTallaTIoN/opeRaTIoN/SeRvIceMaNual pg.17
OPERATION
Cook/Hold/Smoke Instructions
Press and release control ON/OFF key. The oven will beep for one second and power to the unit will be
indicated by an illuminated green indicator light located in the upper left corner of the ON/OFF key. The
oven will begin operating in the hold mode. The amber hold indicator will be illuminated and the last set
hold temperature will be displayed.
Set cook temperature — Press Key. Oven preheat indicator will illuminate and the last set cooking
temperature will displayed. Press the or Keys to change the cook temperature.
If cooking by time — Press the Key. The green time indicator will illuminate and the last set
cooking time will be displayed. Press the or Keys to change the set time. The
display will alternate between the set temperature and the elapsed time.
If cooking by probe — Press the Key. The green probe indicator will illuminate and the last set
internal product temperature will be displayed. Press the or Keys to change the
set temperature. The display will alternate between the set temperature, the elapsed time, and the probe
temperature.
Set hold temperature — Press the Key. The green cook indicator light will remain illuminated.
Press the or Keys to change set hold temperature. The display will alternate between
the set hold temperature and the amount of time the product has been in the hold mode. Oven will remain
in the hold mode until the Key is pressed.
To enable Probe Hold mode (optional when cooking by probe) — Press the Key. The probe
cooking temperature will be displayed. Press the key again to toggle to the Probe Hold temperature.
The yellow LEDs below the and keys will alternate, signaling the Probe Hold mode. Press
the or Keys to set probe holding temperature.
Set Smoke time if desired (hot smoke) — Press Key. Press the or Keys to
set the smoke time desired. The last set time will be displayed.
To save program to a preset — Select desired key (A-H) for the product programmed by the
previous steps. Press and hold the selected Key for two seconds. When the preset has been saved,
you will hear a one second beep and the preset light will illuminate.
Note: Only one preset can be programmed at a time. If programming an additional preset is desired, the unit must be
started and stopped either by cycling the power to the cavity or by pressing the key. The last
Key used will be the oven cooking run sequence for the next product to be programmed. Settings can be manually
changed for the next product and an alternate pre-programmed letter key selected.
Start cooking cycle - Press Key.
To Cook/Hold/Smoke using Preset Menu Keys
Press desired Key (A through H). P Keys with stored cooking programs will have
green indicator illuminated. The oven will automatically enter preheat mode. Oven will beep
periodically when it has reached a preheat ready state, and both the Ready and Start indicator lights
will flash.
Start cooking cycle - Press Key.
To Erase a Preset — Oven must be in either the power-up hold mode or in the preheat mode. The oven
cannot be running a Menu program.
When the oven is in the power-up hold mode or in the preheat mode, press and hold the Key and
then the appropriate letter Key to be erased for two seconds. When the preset has been erased the
oven will beep for one second.
IMPORTANT