Filter
Top Products
MN-28907 (Rev 0) • AR-7EVH Electric Rotisserie with Ventless Hood Operation & Care Manual • 7
INSTALLATION
STACKING INSTRUCTIONS
A rotisserie with ventless hood can be stacked on top of a matching
holding cabinet.
Only screws, lock washers, and hex nut are required to fasten units
together when stacking a rotisserie on top of a matching holding cabinet.
All fastening holes have been prepunched. The stacking combination
also requires the minimum clearance of 6-inches (152mm) at the top, back
and both sides.
1. Attach 4: Support Brackets (1010092) and any required feet or
casters (varies) with 4: SC-2191, 4: WS-2867, and 4: WS-22095 to the
bottom unit.
2. Remove the access panels of both units.
3. Punch out the knock out hole (A) in the top panel of the lower unit.
4. Remove power cord from upper unit and discard.
5. The new power cord and strain relief bushing for upper unit
should be routed through the knock out hole in the top panel
of the lower unit.
6. Carefully lift and place the upper unit into position aligning on
bottom unit.
7. Secure units together by inserting a hex head screw and washer
inside upper unit, and back them with a washer, lock-washer,
and nut inside lower unit. Securely tighten all four screws.
8. Attach a strain relief bushing to the bottom panel of the lower
unit to the left of the existing power cord. (B)
9. Route power cord from upper unit through the strain relief
bushings, then tighten bushings.
10. Replace the access panels on both units.
1
2
2
3
4
7
6
5
A
B
8
AR-7EVH oVER AR-7H stAcking AssEmbly
ITEM PART NO. DESCRIPTION QTY
1 SC-27385 SCREW, 1/4/20 X 3/4" LG HEX HEAD 4
2 WS-22094 WASHER, 1/4", FLAT, 5/8 OD 18-8 SS 8
3 WS-2294 LOCK WASHER, 1/4" 4
4 NU-2437 NUT, 1/4-20 HEX S/S 4
5 CD-3987 CORD, 8/4 SEEO W-A, 105C, (-50C) 1
6 BU-33948 BUSHING, STRAIN RELIEF, 18MM-25MM AR-7E 1
7 1010092 BRACKET, SUPPORT, BASE 4
8 SC-2191 SCREW, HEX HEAD, 5/16-18 X 1" LONG 16
9* CR-3801* CONNECTORS, *CT, RING, 10MM, SQ/M6 4
10* WS-22095 WASHER, 3/8" ID, 1" OD, FLAT, 18-8 SS 16
11* WS-2867 LOCK WASHER, 5/16" 16
*not shown