Filter
Top Products
P R O G R A M M I N G T H E C O N T R O L
“
Product”
“ShakTime”
The “ShakTime” sub-menu provides the operator with a programmed time period
during which the baskets will automatically lift to half the normal raised position so
that the operator can shake each basket. When programmed into a product procedure,
an alarm will sound to alert the operator at the start of the “ShakTime” cycle and
will continue until the activated product key is pressed. The amount of “ShakTime”
can only be programmed up to the maximum amount of frying time allotted to the
programmed product.
There is no “ShakTime” programmed into any of the products shown on the
product chart. The control provides shake time adjustment from “OFF” up to a
period of 60 minutes. When received from the factory, shake-time will indicate
“OFF” in the display for all programmed preset items.
Press the right
arrow key to enter the “ShakTime” sub-menu. Display stops
flashing. Press the Up or Down arrow keys to change the setting. When the
desired amount of “ShakTime” appears, press the right arrow key to confirm the
setting. If no shake time is required, press the Down arrow key and scroll until
“OFF” appears in the display. When the correct setting appears, press the right
arrow key to confirm. Display flashes. Press the down arrow key to advance the
control to the next sub-menu setting.
O F F
ShakTime
Product
To exit the control programming mode at any time, press and hold the LEFTarrow key.
El ec tr ic Fryer Op er at io n & Ca re M an ua l • 34
D E L U X E C O N T R O L O P E R A T I O N