Alto-Shaam HN2-72/PL; HN2SYS-72/PL Food Warmer User Manual


 
O P E R AT I N G I N S T R U C T I O N S
HN2 & HN2SYS Series Operation & Care Manual 7
U S ER S A FE T Y IN F O RM AT I ON
T
he Alto-Shaam heated display case is intended
for use in commercial establishments by qualified
operating personnel where all operators are
familiar with the purpose, limitations, and
associated hazards of this appliance. Operating
instructions and warnings must be read and
understood by all operators and users.
S TA RT- U P O P E RATI O N
BEFORE INITIAL USE:
Interior display case surfaces must be heated to
remove surface oils and the accompanying odor
produced during the first use of the appliance.
Remove pans. Turn thermostats to the “ON”
position. Set thermostats to the 10 setting. Allow
the unit to heat for 30 minutes or until no odor
is detected.
PREHEATING :
The unit should be preheated at the 10 setting
for a minimum of 30-45 minutes before loading
the case with hot food. Follow the operating
instructions indicated on the next page of
this manual.
D A N G E R
AT NO TIME SHOULDTHE INTERIOR
OR EXTERIOR BE STEAM CLEANED,
HOSED DOWN, OR FLOODED WITH
WATER OR LIQUID SOLUTION OF
ANY KIND. DO NOT USE WATER JET
TO CLEAN.
SEVERE DAMAGE OR
ELECTRICAL HAZARD
COULD RESULT.
WARRANTY BECOMES VOID IF
APPLIANCE IS FLOODED
D A N G E R
DISCONNECT UNIT FROM
POWER SOURCE BEFORE
CLEANING OR SERVICING.
W A R N I N G
Hood glass extended to the full,
upright portion is stabilized through
the use of gas struts designed for
the full, load-bearing weight. These
struts could weaken or fail due to
wear, environmental conditions or
aging. OPERATORS SHOULD BE
AWARE OF ANY DECREASE IN
EFFORTTO LIFT THE HOOD AND
INITIATE AN IMMEDIATE GAS STRUT
SAFETY CHECK. DO NOT LIFT THE
HOOD IN THIS CONDITION.
C A U T I O N
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN IN
OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.