Alto-Shaam QC2-100 REMOTE Freezer User Manual


 
QUICKCHILLER • MN-29647 (REV. 0) • INSTALLATION/OPERATION/SERVICE MANUAL • 23.
ADVANCED OPERATION – USER SETTINGS
OPERATION
9. PROBE VERIFICATION
With the probe verification selected, press the Start
key to enter the probe verification mode.
The offset and the temperature will display for:
Top Probe
(where applicable)
Middle Probe (where applicable)
Bottom Probe (where applicable)
If probe calibration is needed, place the probe
in a glass of ice-water and let the probe settle in
temperature. The temperature in the glass should
be 32°F (0°C).
To calibrate, Press up5or down6arrow key to
adjust between the probes, and the right4or
left3arrow keys to adjust the calibration value.
Press the PROGRAM key to exit probe
calibration mode.
10. PRESET LOCK (0=UNLOCKEd, 1=LOCKEd)
I
o
If the presets are locked, pressing start on
the desired preset will skip the mode
overview and will start immediately.
Factory default is locked.
11. CHILL MODE LOCK (0=UNLOCKEd, 1=LOCKEd)
I
o
If the chill modes are locked, pressing the
chill mode button will skip the mode
overview and will start immediately.
Factory default is unlocked.
12. DEFROST TIME (MINUTES)
This is the amount of time the defrost function
will run before automatically switching back to the
chilling mode. Factory default setting is 20 minutes.
The user may select a range from 10-30 minutes
using the right4or left3arrow key to increase or
decrease the numbers as required.
13. DRIP TIME (MINUTES)
This is the amount of time the drain heater will run
after a hot-gas defrost function before automatically
switching back to the chilling mode. Factory default
setting is 10 minutes. The user may select a range
from 5-15 minutes using the right4or left3arrow
key to increase or decrease the numbers as required.
14. FACTORY SETTINGS
Resets all presets and user-defined settings to
factory default settings. 


