Filter
Top Products
QUICKCHILLER • INSTALLATION/OPERATION/SERVICE MANUAL • 19.
ADVANCED OPERATION — PRESET PROGRAMMING
OPERATION
PRESET PROGRAM OPERATION
1. Starting from the off position, press the power
key on. The Alto-Shaam name will illuminate
and the SELECTION SCREEN will appear on the
display. The compressor will become energized
and will begin to operate if required by the
sensors.
2. At the SELECTION SCREEN press the START/STOP
key to access the presets.
The first five of the following preset menu
selections will appear in the display.
3.
Press the up
5or down6arrow keys to scroll
through the preset menu items.
4. When desired preset is highlighted, press
the START/STOP key.
The Quickchiller will show the values
previously programmed by the operator or
will begin chilling if the Presets are locked.
5. Press the START/STOP key again to begin
operation.
PROGRAMMING PRESETS
1. Starting from the off position, press the power
key on. The Alto-Shaam name will illuminate and
the SELECTION SCREEN will appear on the display.
The compressor will become energized and will
begin to operate if required by the sensors.
2. At the SELECTION SCREEN press the START/STOP
key to access the presets.
3. Press the up5or down6arrow keys
until the arrow points to the preset menu
program desired.
4. Press the START/STOP key.
Press the desired mode key.
Press the up5or down6arrow keys to
adjust temperature.
The display will give an overview of the current
set-temperatures for the mode.
To change the settings
for the desired mode,
press the PROGRAM key.
5. The Display will require the operator to select
between chilling by PROBE or by TIME.
Select the desired chill method (time or probe)
by pressing the right4or left3arrow keys.
If TIME was selected, use the right
4or
left3arrow keys to highlight chill, hold, or
time, then press the up5or down6arrow
keys to change accordingly.
If PROBE was selected, select top, middle and
lower probe using right
4or left3arrow keys
and then press the up5or down6arrow keys
to change accordingly.
QC2-3 and QC2-20 will display only
one probe.
6. If settings are acceptable, press the START/
STOP key. The preset
settings will be saved and the operation
will begin.
PRESET SELECTIONS
1.
Beans
11.
Pork
2.
Beef
12.
Potatoes
3.
Casserole
13.
Rice
4.
Chicken Breast
14.
Sauce
5.
Chicken Whole
15.
Sheet Cake
6.
Duck
16.
Soup
7.
Fish
17.
Stew
8.
Ground Meat
18.
Stufng
9.
Lamb
19.
Turkey
10.
Lasagna
20.
Vegetables