Filter
Top Products
Electrical Requirements
Observe all governing codes and ordinances.
Required:
■ A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a
fuse or circuit breaker.
Recommended:
■ A time-delay fuse or time-delay circuit breaker.
■ A separate circuit serving only this microwave oven.
Settings
Clock
The Clock is a 12-hour (12:00-11:59) clock, with A.M. and P.M. Touch
CLOCK, enter time, then touch CLOCK or the Start control.
Timer (on some models)
Timer can be used independently during any cooking program. Touch
the Timer control, enter time, then touch the Timer control or the Start
control.
Control Lock
Activate to avoid unintended start. Touch and hold the Cancel control
for about 3 seconds until 2 tones sound and padlock icon appears in
the display. Repeat to unlock control.
Options or Setup
Vent Timer, Light Timer, Filter Reset, Sound On/Off, Scroll Speed,
Demo Mode and Language (on some models - English or French) may
be changed.
Vent Fan
Various speeds, ranging from high to low, and off. Comes on
automatically as cooling fan during any cook function.
Vent Timer (on some models): Set vent fan to run for exactly
30 minutes, or to run for only 30 minutes more (off after 30 minutes).
The vent fan may be turned off at any time using the Vent Fan control.
Touch the Options or Setup control to reach the “Vent Fan” submenu,
and select the setting.
Light Timer
Set the cooktop light to turn on and off at certain times. Touch Options
or Setup control to reach the “Light Timer” submenu, and set the Light
On Time and Light Off Time in hours and minutes with A.M. or P.M.
Filter Reset
Reset the filter status after replacing and/or cleaning the filters. Touch
Options or Setup control to reach the “Filter Reset” submenu and
activate reset. See “Microwave Oven Care” section.
Tones
Programming tones and signals. Programming tones may be turned
off, or all tones (including end-of-function signals) may be turned off.
Touch the Options or Setup control to reach the “Sound On/Off”
submenu, and turn tones off or on.
Scroll Speed
Scroll speed of the text may be adjusted. Touch the Options or Setup
control to reach the “Scroll Speed” submenu, and select the scroll
speed. Touch the Start control to set speed.
Demo Mode
Activate to practice using the control without actually turning on the
magnetron. Touch the Options or Setup control to reach the “Demo
Mode” submenu, and activate or deactivate Demo Mode.
Energy Save
To conserve energy, Energy Save may be activated, and the display
will go dark whenever the microwave oven is in standby mode.
Touching any control pad or opening the door will wake up the display.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
GROUNDING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
■
For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
This device complies with Part 18 of the FCC Rules.
OPERATING YOUR MICROWAVE OVEN