Filter
Top Products
16
What cleaners does
Amana recommend for my
stainless steel product?
Amana has a cleaner available for pur-
chase (Part # 31960801) through our
Consumer Affairs division.
For this, or a list of other recommended
cleaning products, please contact us at
Amana Consumer Affairs using the infor-
mation on the cover of your Owner's
Manual.
Removing odors from
refrigerator
1. Remove all food.
2. Disconnect refrigerator.
3. Clean the following items using the
appropriate instructions in the Care
and Cleaning table.
–Walls, floor and ceiling of cabinet
interior
– Drawers, shelves and gaskets
according to the instructions in this
section.
4. Pay special attention to clean all
crevices by completing the following
steps.
– Dilute mild detergent and brush
solution into crevices using a plas-
tic bristle brush.
– Let stand for 5 minutes.
– Rinse surfaces with warm water.
Dry surfaces with a soft, clean
cloth.
5. Wash and dry all bottles, containers
and jars. Discard spoiled or expired
items.
6. Wrap or store odor-causing foods in
tightly sealed containers to prevent
reoccurring odors.
7. Connect power to refrigerator and
return food to unit.
8. After 24 hours, check if odor has been
eliminated.
If odor is still present:
1. Remove drawers and place on top
shelf of refrigerator.
To avoid personal injury or property
damage, observe the following:
➢ Allow light bulb to cool.
➢ Wear gloves when replacing light
bulb.
CAUTION
To avoid electrical shock which can
cause severe personal injury or death,
disconnect power to refrigerator
before replacing light bulb. After
replacing light bulb, connect power.
WARNING
2. Pack refrigerator and freezer sections
– including doors – with crumpled
sheets of black and white newspaper.
3. Place charcoal briquettes randomly on
crumpled newspaper in both freezer
and refrigerator compartments.
4. Close doors and let stand 24-48
hours.
Energy saving ideas
➢ When placing refrigerator into final
position, allow for
1
Ú2" clearance around
the top and sides of the unit to supply
ample ventilation for optimum energy
efficiency.
➢ Avoid overcrowding refrigerator
shelves. This reduces air circulation
around food and causes refrigerator to
run longer.
➢ Avoid adding too much warm food to
unit at one time. This overloads com-
partments and slows rate of cooling.
➢ Do not use aluminum foil, wax paper,
or paper toweling as shelf liners. This
decreases air flow and causes unit to
run less efficiently.
➢ A freezer that is
2
Ú3
full runs most effi-
ciently.
➢ Locate refrigerator in coolest part of
room. Avoid areas of direct sunlight, or
near heating ducts, registers or other
heat producing appliances. If this is
not possible, isolate exterior by using
a section of cabinet or an added layer
of insulation.
➢ Refer to Owner's Manual section on
temperature controls for recommend-
ed control settings.
➢ Clean door gaskets every three
months according to Owner's Manual
cleaning instructions. This will assure
that door seals properly and unit runs
efficiently.
➢ Take time to organize items in refriger-
ator to reduce time that door is open.
➢ Be sure your doors are closing
securely by leveling unit as instructed
in your Owner's Manual.
➢ Clean condenser coils as indicated in
the Owner’s Manual every 3 months.
This will increase energy efficiency
and cooling performance.
Remove and replace
light bulbs
Fresh Food Section
1. Slide shield toward
back of compartment
to release from light
assembly.
2. Remove light bulbs.
3. Replace with appliance bulbs no
greater than 40 watts.
4. Replace light bulb
cover by inserting
tabs on light shield
into liner holes on
each side of light
assembly. Slide shield toward front of
unit until it locks into place. DO NOT
force shield beyond locking point.
Doing so may damage light shield.
Freezer
1. Pinch rear tabs on
light cover and pull
straight down.
2. Remove light bulb.
3. Replace bulb with appliance bulb no
greater than 40 watts.
4. Insert front tabs of light cover into
freezer liner and snap rear portion
over light assembly until rear tabs
engage.
A
B
Hints and care,
cont.