Filter
Top Products
Procedure
1. Slide out refrigerator handle screw insert and remove
handle by removing screws with a Phillips
screwdriver.
Refrigerator
handle
Handle
insert
Handle
screws
2. Align panel in groove between top and bottom trim
and push evenly. Start at one end and work across
door. If panel binds loosen top door trim. Adjust
panel and retighten.
Refrigerator
handle
Decorator
panel
IMPORTANT:
Do not remove corrugate from back of panels. Panels
will not fit properly if corrugate is removed.
• For ease of installation, two people are required to
lift and guide panel into trim. Install one panel at a
time.
• For smoother installation apply bar soap on door
trim and panel.
3. Reinstall handle with screws removed in step 1.
Install handle screw insert by starting at one end and
working upward along the full length of handle.
4. Slide out handle screw insert from top of freezer
drawer. Remove freezer drawer handle screws.
Remove handle. Handle is in two pieces,
reassemble if handle pieces come apart.
Handle screw insert
Handle screws
Handle
5. Align panel in groove between left and right freezer
drawer trim. Push evenly. If panel binds loosen
Freezer drawer side trim. Adjust panel and retighten.
Freezer drawer
handle
Decorator
panel
IMPORTANT:
Do not remove corrugate from back of panels. Panels
will not fit properly if corrugate is removed.
• For smoother installation apply bar soap on door
trim and panel.
6. Reinstall handle by replacing screws removed in step
4. Install handle screw insert by starting at one end
and working across the full length of the handle.
7. Peel off protective film from the front of decorator
panels.
Part No. 10599707
Printed in U.S.A.
©
1997 Amana
Amana, Iowa 52204