Filter
Top Products
8
CASTER LEVELING INSTRUC-
TIONS
1. Move the fryer to its desired location.
2. Determine whether the fryer tends to wobble
or rock when in its desired location. If it
does, perform steps 3 through 9. If it does
not, skip to step 10, then proceed to the
Installation Instructions.
WARNING
The fryer MUST NOT tip, rock or wob-
ble, to avoid splashing or spilling its HOT
shortening contents during operation.
3. Determine which caster requires adjustment
and the approximate amount of change
required to level the fryer.
4. Position the side of the fryer on the ship-
ping carton, exposing the bottom of the fryer
(Figure 5).
5. Completely remove the bolts holding the
caster mounting plate that requires leveling
adjustment. Retain the bolts for later
reassembly.
!
INSTINST
INSTINST
INST
ALLAALLA
ALLAALLA
ALLA
TION REQTION REQ
TION REQTION REQ
TION REQ
UIREMENTS UIREMENTS
UIREMENTS UIREMENTS
UIREMENTS (Continued)
Figure 4. Typical Caster Installation
CASTER INSTALLATION
INSTRUCTIONS
1. Flatten the shipping carton (after unpacking the
fryer and its parts and accessories) for surface
protection during caster installation.
2. Position the side of the fryer flat on the carton,
exposing the fryer bottom mounting brackets
for caster installation, as shown in Figure 4.
3. Mount locking casters on the front of the fryer
and fixed casters on the rear, by placing each
caster mounting plate on the fryer bottom.
4. Insert one mounting bolt through the proper
hole in the caster mounting plate and start it
into the proper hole in the fryer mounting
bracket.
5. Screw a locking nut several turns onto the
mounting bolt.
6. Repeat steps 4 and 5 until all four mounting
bolts for each leg are in place with locking nuts.
7. Tighten the four bolts evenly and
securely to hold the caster mounting plate
against the bottom of the fryer.