Filter
Top Products
DISASSEMBLY
USE CAUTION
Do not use any chloride or chlorine-based products to clean or rinse toaster or toaster parts.
Daily Parts Cleaning:
Daily Conveyor Cleaning:
Conveyor may be hot and is heavy, use caution when lifting and removing.
Use caution when handling a hot conveyor.
Lubricate both chains thoroughly with
vegetable oil. Note: Chain
Lubrication is critical to chain life. Oil the chain daily.
Discard used soak solution. Clean and sanitize sink or container after over night use!
.
Daily Griddle Cleaning:
Wet Operation:
Tools needed for cleaning:
Turn off main power switch and conveyor switch. Disconnect the power supply cord from the wall
outlet. The toaster will be hot when turned off. Allow the toaster to cool for at least 15-30 minutes
before handling. during disassembly and cleaning. Grasp the left side of the Butter
Roller Shaft. Lift up and to the left to remove from drive assembly. Remove the Butter Pan. Remove
the Top and Bottom Control Panels.
The Butter Roller, Butter Pan, Feeder, and Top and Bottom Control Panels can be placed in a
dishwasher or sink and washed with mild detergent and warm water.
Remove
conveyor assembly by simply pushing back on the top row of paddles on conveyor. Conveyor
should loosen from gears and you should grab handles and pull upward. Pull out gently placing it in
a sink with the drain stopped, or in a suitable container to soak over night. Conveyor can be placed in
the sink or container while warm. The soak solution
is a mix of 10 parts hot water (120ºF or more) to 1 part (minimum) “INSIDE OUT” brand 3-IN-1. Fill
the sink or suitable container with the solution, to completely cover the conveyor by approximately
one inch. Allow the conveyor to soak in the solution overnight. Remove the conveyor from the
solution. Use a stiff non-metal brush or plastic pad to remove residual bun oil. Insure the chains are
clean and free from debris. Use a brush to remove any soil or debris remaining on the chain. Rinse
conveyor with plain hot water and allow to drain.
Bun oil may be used if it contains no animal fats, salts or dairy products.
Gently replace conveyor into toaster.
Replace all removed toaster parts. Plug power supply cord into wall outlet. Turn main power switch
on. Turn conveyor switch on.
The conveyor must stay clean to optimize speed and buntemperature
It is not necessary to completely remove residue, as long as the grill surface is smooth and free of
burned on bread that may cause buns to stick. To remove baked-on-bread use the cleaning
procedure below.
Scotch-Brite Quick Clean SmallAppliance Cleaner No. 702 or Equivalent
Scotch-Brite Multi-Purpose Pad Holder No. 405 or Equivalent
Scotch-Brite Squeegee No. 410 or Equivalent
Scotch-Brite Griddle Polishing Pad No. 46 or Scotch-Brite™ General Purpose Scrubbing Pad No.
9650 or Equivalent
NOTE:
NOTE:
7. CLEANING
WARNING: Make sure the toaster is in the off position and has been off at least 15 -30 minutes.
attempt this cleaning procedure if the toaster components are too hot to touch. Never spray
water on the toaster or controls. Damage to the toaster as well as injury could occur. Severe injury
and burns may occur if you do not follow this instruction sheet.
WARNING: Do not use a grill brick or grill screen to clean the griddle plate. Use of these products
will scrape the plating off of the griddle surface causing buns to stick tothe grill plate.
Do
not