Filter
Top Products
3) Preventative Maintenance -
Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves
when removing the top cover, cleaning the Release Sheet, and cleaning the silicone belt.
Monthly
WARNING!
A. In addition to the daily cleaning described above, remove and
clean silicone belt. Remove the top cover and bun chute and
clean with detergent in a sink. Open one of the side panels (front
or rear) exposing the orange silicone belt. By depressing the
safety interlock switch at the top of the toaster, rotate the
conveyor so that the “flap” is in the front of the conveyor.
Do not allow articles of clothing, hands, fingers, or
any foreign objects from being caught in the rotating conveyor
belt. To stop the conveyor from turning, release the safety
interlock switch.
WARNING!
Slide the pin that runs through the zipper under the
flap of the belt by grasping it with a pair of needle
nose pliers and pulling sideways. DO NOT
DISCARD THE PIN. Once the belt is removed, lay
it out flat on a clean surface. Using a standard
cleaner, wipe down both sides of the belt until clean.
Follow cleaning by wiping down both sides of the
belt with a standard sanitizer.
B. Brush out the conveyor chain and sprockets. Using a soft brush, remove any
food particles that may have built up under the silicone belt. Visually inspect the drive
sprockets to verify that food particles have been cleared away. Wipe down the metal chain
with a soft cloth and standard cleaner. Follow cleaning by wiping again with a standard
sanitizer.
C. Clean the release sheet tensioning roller. Wipe down the roller with a standard cleaner.
Follow cleaning by wiping down again with a standard sanitizer. Spin the roller to make sure
that it turns freely.
D. Replace the silicone belt. Wrap the silicone belt around the metal conveyor chain, with the
top flap located at the top of the conveyor. THE TOP FLAP MUST BE POSITIONED
PROPERLY THE OPENING THAT EXPOSES THE ZIPPER SHOULD BE IN FRONT OF
AND ACCESSIBLE TO YOU, ROTATING UP AND TOWARD THE PLATEN AS THE
CONVEYOR TURNS. (See diagram)
With one hand, hold the zipper together on one edge of the belt. With the other hand, start to
slide the pin through the zipper, securing the belt to the conveyor. You may have to use the
needle nose pliers to slide the pin all the way through the zipper. MAKE SUREALL OF THE
TEETH ON THE ZIPPER ARE LINED UPAND OPPOSITE EACH OTHER,AND THE PIN IS
STICKING OUT EQUALLY ON EITHER SIDE OFTHE SILICONE BELT.
4) Preventative Maintenance -
Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves
when removing the top cover, cleaning the Release Sheet, and cleaning the silicone belt.
A. In addition to the daily cleaning described above, remove and inspect the silicone belt. If
worn, brittle, or damaged, replace the belt with a new one according to section 12, Procedure
for Changing a Belt (see page 18).
3 to 6 Months
WARNING!