Filter
Top Products
ARISTON DISHWASHER - User Manual 5
www.aristonappliances.us
You have loaded your dishes and you now have to set
the wash cycle. It takes just one minute to learn how
Starting the dishwasher
Ready, steady, go!
You can cancel the
wash cycle in progress,
if it has only just started.
Make sure the wash
cycle has ended before
removing the dishes!
Selecting the wash cycle.
Select the wash cycle by
pressing button "P". Each
time this button is pressed,
one of the indicator lights
"M" will come on in
sequence, select the wash
cycle you deem most
suitable for the type of
dishes to wash (take a look
at page 7, where you will
find the wash cycle table).
Close the appliance door
and after a few seconds,
you will hear a short beep:
the wash cycle has begun.
Modifying a wash cycle in
progress.
If you have chosen the
wrong cycle, not to worry!
You can modify the wash
cycle in progress, if it has
only just started. Open
the appliance door
carefully to avoid any hot
water splashes, then
keep button "P" pressed
for approximately 5
seconds, until you hear a
short beep. Indicator light
"M" will come off and at
this point, all the settings
will have been cancelled.
You are now free to re-set
the correct wash cycle.
You've left out a dish?
Well, it happens to
everyone. Interrupt the
wash cycle by opening the
appliance door with the
utmost care, as usual, then
insert the dish you had
forgotten. When you shut
the appliance door, the
cycle will start up from
where you interrupted it.
Finished?
The end of the wash cycle
is indicated by a double
beep and the flashing of the
wash cycle indicator light
"M". Open the dishwasher
door, press the ON-OFF
button as well, thus cutting
off the electricity supply to
the appliance.
If accessible turn off the
water tap.
Wait a few minutes before
unloading the dishes: they
are very hot! If you wait a
little while, they dry better
thanks to the steam.
Empty the lower rack
first.
There's been a power
failure? Have you opened
the dishwasher door?
The wash cycle stops and
then restarts when the
electricity comes back on
or when you shut the door.
Everything is under control!
After performing all the
operations described in the
previous paragraphs,if
accessible turn the water
tap on, open the appliance
door and press on-off
button "A": indicator light
"B" comes on.
Your appliance is now on
and awaiting instructions.
If opening the
door soon
after the end
of the program, or
during it, stand away
from the Dishwasher,
to avoid possible
injury from hot steam.
Do you want extra drying?
Press button "E" before you
start the selected wash
cycle. A long beep will tell
you that you have selected
extra drying and the wash
cycle will last longer in
order to provide you with
drier dishes.