Filter
Top Products
18
EN
Starting the dishwasher
1. Turn the water tap on.
2. Press the ON/OFF button: the indicator light will
illuminate.
3. Open the door and pour in a suitable amount of
detergent (
see below
).
4. Load the racks (
see Loading the racks
) and shut
the door.
5. Select the desired wash cycle depending on the
dishes and how dirty they are (
see table of wash
cycles
), by turning the knob clockwise.
6. After a few minutes the cycle start and the WASH
CYCLE PHASE indicator lights display the status
of the cycle:
Pre-wash, Wash, Rinse, Drying.
7. At the end of the cycle two short beeps will
sound and the DRYING indicator light will flash.
8. Turn the knob anti-clokwise to RESET in order to
reset all the settings.
9. Switch off the appliance by pressing the ON/OFF
button, shut off the water tap and unplug the
appliance from the electricity socket.
10.Open the door and wait for a few minutes before
removing the crockery, in order to avoid burns.
Unload the racks, beginning with the lower level.
Modifying the duration of a wash cycle already in
progress
If a mistake was made during the wash cycle
selection process it is possible to change the cycle,
provided that it has only just begun: turn the knob
anti-clockwise until it reaches the RESET position.
After a few seconds one long beep and three short
beeps, the WASH CYCLE PHASE indicator light will
switch off: select the new cycle.
Adding extra crockery
Press the ON/OFF button and open the door, taking
care to avoid the escaping steam, and place the
crockery inside the dishwasher. Press the ON/OFF
button again: the cycle starts from the point at which
it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if
there is a power cut, the cycle stops. It starts again
from the point at which it was interrupted once the
door has been shut or the electricity supply is
restored.
Loading the detergent
A successful wash also depends on the correct
amount of detergent being used, as recommended
by the manufacturer. Exceeding the recommended
amount does not result in a more effective wash and
pollutes the environment.
To obtain the best results from each washing and
drying cycle, powder detergent, rinse aid liquid and
salt should be used.
comparcompar
comparcompar
compar
tment Atment A
tment Atment A
tment A: Washing detergent
comparcompar
comparcompar
compar
tment Btment B
tment Btment B
tment B: Pre-wash detergent
1. Open cover C by
pressing button D.
2. Pour in the detergent
after consulting the
Wash
cycle table
:
• for powder detergent
use compartments A and
B
• for tablets, use
compartment A and the
bottom of the appliance,
i.e. when the cycle
requires 1 tablet, place it in compartment A and
close the cover; when it requires 2, place the second
tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
A
B
D
C
Start-up and use
* Only available in selected models.
Extra drying*
To make sure that the crockery is completely dry at
the end of the cycle, press the EXTRA DRYING
button before selecting the wash cycle. A prolonged
beep will sound to indicate that this option has been
selected and a short beep will sound to indicate
when it has been deselected.
If the Extra drying option is selected, the wash
cycles will last longer.
Washing options