Filter
Top Products
Page 12
TROUBLESHOOTING, continued
Dishwasher does not drain properly
♦ Make sure that the cycle was complete before you
opened the dishwasher. If not, allow it to complete
and check again.
♦ Some water left in the sump area near the drain is
normal.
♦ If the plumbing code in your area requires an air
gap, make sure that the air gap isn’t blocked or
plugged.
♦ If the unit is connected to a garbage disposer, make
sure the disposer is empty.
♦ If water backs up into the sink, check the garbage
disposer and trap for blockage.
♦ Check the dishwasher filters and drain area for
blockage. (See page 8.)
♦ Check for a kink in the drain hose.
Dishwasher does not fill properly
♦ Make sure the water supply is turned on.
♦ Make sure the dishwasher is turned on and the door
is closed securely.
♦ Check for crimps in the water feed line.
♦ The system is designed to detect an overflow. When
it does, it shuts off the inlet valve and circulation
pump and turns on the drain pump. (See “Overfill
Protection” on page 9.)
Dishwasher will not start
♦ Make sure the dishwasher is turned on and the door
is closed securely.
♦ Check that the water supply is connected properly
and the water is turned on.
♦ Make sure the power cord is properly plugged into
the wall socket.
♦ Check your fuse box for a blown fuse or tripped circuit
breaker.