Filter
Top Products
14
Installing the Shuttle (DT102, DT85 and DT7 ) into the DKP102
Pressing the Open button will unlock the shuttle housing and it will drop down slightly. Pivot the housing
downward until it is at a right angle to the main unit.
180°
(Optional)
Shuttle Housing
AV1 Input
1) Lift the shuttle clamp (1) up to the top.
2) Install the lower (2) portion of the shuttle into the bottom of the shuttle housing (3).
3) Gently push the upper portion (4) of the shuttle into the shuttle housing and lower the shuttle
clamp (1) to hold the shuttle in position.
4) Rotate the shuttle housing until the back portion is visible. Gently tighten the locking screw on
the rear of the shuttle housing.
1
3
2
4