9
IMPORTANT SAFETY INSTRUCTIONS
?WARNING?
To reduce the risk of fire, electrical shock,
or injury when using your appliance, follow
these basic precautions:
? Read all instructions before using the refrigerator-freezer.
? DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or
abandoned refrigerator-freezers are still dangerous. . . even if they will “just sit in the
garage a few days.”
? Before you throw away your old refrigerator-freezer: Take off the doors. Leave
the shelves in place so that children may not easily climb inside.
? Never allow children to operate, play with, or crawl inside the refrigerator-freezer.
? Never clean refrigerator-freezer parts with flammable fluids. The fumes can create a
fire hazard or explosion.
? Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other refrigerator-freezer. The fumes can create a fire hazard or
explosion.
-Save these instructions-
INSTALLATION INSTRUCTIONS
Before Using Your Refrigerator/freezer
? Remove the exterior and interior packing.
? Check to be sure you have all of the following parts:
? 1 Shelf in Freezer Section
? 2 Shelves in Refrigerator Section
? 1 Crisper
? 1 Crisper Glass Lid
? 1 Ice Cube Tray
? 1 Instruction Manual
? Before connecting the refrigerator/freezer to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
? Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Refrigerator/freezer
? This appliance is designed to be free standing only, and should not be recessed or built-in.
? Place your refrigerator/freezer on a floor that is strong enough to support the
refrigerator/freezer when it is fully loaded. To level your refrigerator/freezer, adjust the leveling
leg at the bottom of the refrigerator/freezer.
? Allow 5 inches of space between the back and sides of the refrigerator/freezer, which allows
the proper air circulation to cool the compressor.
? Locate the refrigerator/freezer away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the
refrigerator/freezer not to perform properly.
? Avoid locating the refrigerator/freezer in moist areas.
? Plug the refrigerator/freezer into an exclusive, properly installed-grounded wall outlet. Do not