Filter
Top Products
11
Cup Dispenser (Optional)
A cup dispenser may be installed by using the mounting holes (covered with plastic caps) located near
the top of the right side panel of the cooler. The cup dispenser comes equipped with a mounting bracket
and screws and may be ordered by completing the enclosed order form provided with your instruction
manual.
CARE AND MAINTENANCE
? Wash the inside of the reservoir with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
? The drip tray and water faucets should be cleaned with mild detergent and warm water.
? At regular intervals or once a month inspect the coils located across the back of the dispenser.
Vacuum accumulation of dust or clean it with a hard brush.
TAKING DISPENSER OUT OF SERVICE
? If the water dispenser will not be used for a long period of time, unplug the power cord from the wall
outlet.
? Drain the water through the faucets.
? Turn the switch market hot to the “OFF” position.
? Drain the water from the tank by removing the plug from the back of the dispenser.
? Unit should not be transported on the sides. Place it upright if possible and cover it with a blanket.
WARNING—THE WATER COMING OUT OF THE BACK SIDE MARKED “HOT” MAY BE SCOLDING.