Avanti BCAD680 Refrigerator User Manual


 
10
? Setting the Temperature Control
? You can set the temperature as you desire by pushing the UP or DOWN button. When you push
the two buttons for the first time, the LED readout will show the original temperature set at
previous time (the temperature preset at the factory is 38ºF).
? The temperature that you desire to set will increase 1ºF or 1ºC if you push the UP button once, on
the contrary the temperature will decrease 1ºF or 1ºC if you push the DOWN button once.
? The range of the temperature control is from 34 ºF to 43ºF.
? You can select temperature display setting from Fahrenheit to Celsius degree by pushing the UP
and DOWN button at the same time for 5 seconds. Fahrenheit and Celsius degrees indicator will
appear in green color in the “SET” window.
? The temperature inside the unit will be appear in red color in the “DISPLAY” window.
NOTE:
? If the unit is unplugged, power lost, or is turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the appliance will not start.
? Interior Light
The light switch is located on the right of control panel. You can turn the interior light ON or OFF by
pressing the light switch.
? Door Lock
Your unit is provided with a lock and key combination.
The keys are located inside the plastic bag that contains the User’s Guide. Insert the key into the lock
and turn it counterclockwise to unlock the door. To lock the door do the reverse operation making
sure metal pin is engaged completely. Remove the key and place it in a secure place for safekeeping.
? Shelves
? To prevent damaging the door gasket, make sure to have the door all the way opened when
pulling shelves out of the rail compartment.
? For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail
compartment, however this unit was designed with a plastic post on each sides of the shelf tracks
to prevent bottles from falling.
IMPORTANT SAFEGUARDS
Do not store food in Beverage Center, as interior temperature may not get cool enough to prevent
spoilage.
As a natural result of condensation, in summer months or areas of high humidity, the glass door
may build up moisture on the outside. Just wipe it away.